Difference between revisions of "Microduino Communication Modules"

Wired Communication

Microduino-W5500

• Microduino Ethernet module
• Support hardware TCP/IP protocol
• Built-in 10BaseT/100BaseTX Ethernet PHY
• Communicate with Core/Core+ through spi interface
• UPin-27 standard interface

Microduino-ENC28J60

• Main chip: ENC28J60
• Microduino ethnet module
• IEEE 802.3 compitable ethernet controller
• integrate MAC and 10 BASE-T PHY, support POE
• use SPI communication protocol
• UPin-27: Microduino standard interface

Microduino-RJ45

• Main chip: ENC28J60
• Microduino ethnet module
• IEEE 802.3 compitable ethernet controller
• integrate MAC and 10 BASE-T PHY, support POE
• use SPI communication protocol
• UPin-27: Microduino standard interface

Microduino-USBHOST

• Microduino USB communication module
• Support USB host controller and USB peripherals
• UPin-27 Microduino standard interface

Microduino-RS485/zh

• Microduino 485 bus serial communication module
• Low power consumption, fast transmission rate and long transmission distance.
• UPin-27 standard interface

Wireless Communication

Microduino-nRF24

• Microduino 2.4G wireless module
• use SPI communication protocol
• Arduino library support

Microduino-smartRF

• 470/950 MHz ISM/SRD band ultra low power wireless communication module
• Use the SPI interface to communicate with Core/Core+ module
• Have corresponding networking library support, can carry on a simple network
• UPin-27 standard interface

Microduino-NFC

• Two-way connection and identification of near-field communication module
• Use IIC interface to communicate with Core/Core+ module
• UPin-27 standard interface

Microduino-BT

• Microduino Shield BT, two versions are provided: BT2.1 and BT4.0
• support BT 2.1/4.0 protocol
• use hardware serial or software serial ports (optional)
• UPin-27: Microduino standard interface

Microduino-Zigbee

• Microduino-Zigbee
• Adopt CC2530 chip
• Low-power, low-rate and low-cost two-way wireless communication
• UPin-27 standard interface

Microduino-WiFi

• Microduino WiFi Module
• Base on TI CC3000 IEEE 802.11b/g solution
• Use the SPI interface to communicate to Core module
• UPin-27: Microduino standard interface

Microduino-WIFI(ESP)

• WIFI communication module
• It can be connected to the Internet
• Communicate data with CoreUSB by serial port

Microduino-GPRS/GSM

• Microduino GPRS/GSM module
• Send, Receive short message
• Access the network using SIM card

Microduino-GPS

• Microduino GPS Module
• Core modules using UBLOX NEO-6M
• Use serial to communicate with Core module
• UPin-27: Microduino standard interface