Difference between revisions of "Sensor-LED"

mCookie-Hall

The product number of mCookie Sensor—LED : MSDL11

mCookie Sensor-LED has red, yellow and green three colors.

Introduction of the Sensor Pin

Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx.

Special to Sensor-LED sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Digital signal output PIN4(IO2): NC Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

Features

• Low consumption
• Convenient interfaces

Specification

• Sensor voltage
  • 3.3V~5V working voltage

• Size of the sensor
  • Size of the board: 23.5mm*13mm
  • 1.27mm-spacing 4Pin interface connected with sensorhub
  • CAD drawing of the sensor: File:Sensor CAD.zip

• Function description
  • LED will twinkle with 1s as the interval.

• Connection
  • This sensor can be connected with the following interfaces of the core: D2~D13

Document

• Schematic diagram: File:Microduino LED.Zip.pdf

Development

Program Download

• Download and unzip the program File:Microduino LED Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Microduino_LED_Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following picture, connect the Sensor-LED to the digital port D6 of Microduino-Sensorhub.

Result

• LED will twinkle with 1s as the interval.

Application

• Indicator lamp

Projects

Purchase

History

Gallery