Difference between revisions of "Sensor-Gesture"

Sensor-Gesture

The product number of Sensor—Gesture is: MSDI81

Sensor-Gesture can detect the movement direction and the distance of hands.

Instruction of Pins

Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx.

Special to Sensor-Gesture sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Analog signal input PIN4(IO2): NC Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

Features

• Adopts APDS9960 sensor and IIC communication.
• With high detection and good stability.
• With small size which is easy to install.

Specification

• Sensor voltage
  • 3.3V~5V working voltage

• Size of the sensor
  • Sensor of the board: 23.5mm*13mm
  • 1.27mm-spacing 4Pin interface connected with sensorhub
  • CAD drawing of the sensor:File:Sensor CAD.zip

• Function description

• • This sensor can detect the movement direction and the distance of hands.
  • This sensor can detect the environment light and the RGB chroma.

• Connection
  • This sensor can be connected to the I2C interface of core.

Document

• Schematic diagram: File:Sensor-Gesture.Zip
• Main chip: File:APDS9960 datasheet.pdf

Development

Program Download

• Download and unzip the program File:File:Sensor-Gesture Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Microduino_Gesture_Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following picture, connect Sensor-Gesture to IIC port of Microduino-Sensorhub.

[[[file:Microduino-sensorhub_I2C.JPG|thumb|400px|left]]

Result

• After download, open the serial monitor.
• Move your hands to left and right toward the sensor, and the serial monitor will print out the corresponding direction, such as UP, DOWN, FAR and so on.

Application

• It can be used in gesture control system.

Projects

Purchase

Gallery