Difference between revisions of "Temperature & Humidity S2 (use with mDesigner)"
From Microduino Wiki
(→Compatible Pins) |
|||
| Line 6: | Line 6: | ||
|} | |} | ||
| − | = | + | =Connectivity= |
The following pins on the '''Hub''' or '''mCenter+'s Hub''' support this module: | The following pins on the '''Hub''' or '''mCenter+'s Hub''' support this module: | ||
<div style="width: 80%;"> | <div style="width: 80%;"> | ||
| Line 105: | Line 105: | ||
<br style="clear: left;" /> | <br style="clear: left;" /> | ||
</div> | </div> | ||
| + | |||
=Block= | =Block= | ||
==Temperature/Humidity Read== | ==Temperature/Humidity Read== | ||
Revision as of 23:10, 11 July 2018
The Temperature & Humidity (S2) sensor is a capable of measuring the current temperature and humidity near the sensor. Support for this sensor is found in mDesigner.
|
Note: |
Connectivity
The following pins on the Hub or mCenter+'s Hub support this module:
| Pin Name | Compatibility | Notes |
|---|---|---|
| Pin 0 | No | |
| Pin 1 | No | |
| Pin 2 | No | |
| Pin 3 | No | |
| Pin 4 | No | |
| Pin 5 | No | |
| Pin 6 | No | |
| Pin 7 | No | |
| Pin 8 | No | |
| Pin 9 | No | |
| Pin 10 | No | |
| Pin 11 | No | |
| Pin 12 | No | |
| Pin 13 | No | |
| Pin A0 | No | |
| Pin A1 | No | |
| Pin A2 | No | |
| Pin A3 | No | |
| Pin A6 | No | |
| Pin A7 | No | |
| Pin I2C | Yes | Any I2C / IIC pin. |
Block
Temperature/Humidity Read
This block reads either the temperature (in Celsius) or humidity (percentage) from the sensor and returns the value.
| Note: This block looks very similar to the Temperature Read block used with the Temperature D1 sensor. Ensure you are using the correct block! |
- Temperature / Humidity - select either Temperature of Humidity to read.
- Temperature - reads the current temperature (in Celsius) from the sensor.
- Humidity - reads the current humidity percentage from the sensor.
