Difference between revisions of "Lesson 39--Microduino Stepper Motor Control steps"

Revision as of 08:52, 8 July 2016

Language:	English • 中文

This lesson will use potentiometer or serial port to control stepper moter's step, that is angle.

ok

Step 1：Open the test program；
Step 2：Compile it and select the board to downlaod
Step 3：Test
- Connect the power (6-25V)；
- Rotate the potentiometer, stepper motor will rotate as the same angle.

Step 1：Open the test program；
Step 2：Compile it and select the board to downlaod
Step 3：Test
- Connect the power (6-25V)；
- Open the serial monitor;
- Input a angle value, then the stepper motor will rotate as input angle value.

Based on Microduino A4982, we can use the potentiometer or serial port to control stepper motor successfully.

@@ Line 39: / Line 39: @@
 Based on Microduino A4982, we can use the potentiometer or serial port to control stepper motor successfully.
 ==Video==
-http://v.youku.com/v_show/id_XNjg5MTcxODg0.html
 |}