Difference between revisions of "Sensor-Temperature-D1"

Microduino-Sensor-Temperature-D1

The product number of Sensor-Temperature-D1 is: MSDT11

Sensor-Temperature-D1 is digital temperature detection sensor module.

LM75 is a temperature sensor produced by National Semiconductor whose output voltage is of Celsius scale.

Introduction of the Sensor Pin

Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx.

Special to Sensor-Temperature-D1 sensor pins PIN1: GND PIN2: VCC PIN3(IO1): SDA PIN4(IO2): SCL Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

Features

• Adopts LM75 temperature whose address is optional.
• With high accuracy and sensitivity.
• With low power consumption, long service life and good stability.
• With wide working voltage.
• With small size which is easy to install.

Specification

• Sensor voltage
  • 3.3V~5V working voltage

• Size of the sensor
  • Size of the board: 23.5mm*13mm
  • 1.27mm-spacing 4Pin interface connected with sensorhub
  • CAD drawing of the sensor: File:Sensor CAD.zip

• Technical parameters
  • Accuracy: temperature 0.125℃;
  • Measuring range: 55℃～+125℃;

• Connection
• This sensor can e connected to the I2C interface of the core.

Document

• Schematic diagram: File:Sensor Temperature D1.Zip

Development

Program Download

• Download and unzip the program File:Sensor Temperature D1 Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Sensor_Temperature_D1_Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following diagram, connect the Sensor-Temperature-D1 to theI2C interface of Microduino-Sensorhub.

Result

• After download, open the serial monitor.
• The serial monitor will print out the configuration information of the sensor, and then display the current temperature in cycle.

Application

It can be used to detect the humidity of the environment, and be sued as temperature switch to control the air conditioner, fan and other devices.

Purchase

History

Gallery

• Front

Microduino-LM75 Front

• Back

Microduino-LM75 Back