Difference between revisions of "Microduino Hall sensor to measure DC motor RPM"

From Microduino Wiki
Jump to: navigation, search
 
Line 42: Line 42:
 
Step 1: Copy the code to IDE and compile it.
 
Step 1: Copy the code to IDE and compile it.
  
Step 2: Set up circuit, as follows:
+
Step 2: Set up circuit, as follows:
  
 
[[File:Microduino霍尔传感器测量电机RPM连接图.jpg|600px|center|thumb]]
 
[[File:Microduino霍尔传感器测量电机RPM连接图.jpg|600px|center|thumb]]

Latest revision as of 10:28, 28 September 2016

Language: English  • 中文

Objective

This lesson will teach you use the hall sensor to measure the RPM(Revolution(s) Per Minute) of DC motor, and display the value on OLED.

Equipment

Schematic

Microduino霍尔传感器测量电机RPM原理图.jpg


Program

https://github.com/Microduino/Microduino_Tutorials/tree/master/Microduino_Sensor/HallSensorSpeedMeasurement

Function description:

attachInterrupt(0, rpm, RISING); //Bind the interrupt to pin 0 which corresponding to port D2 in microduino. When interrupt happened, invoke function rpm(), the trigger condition is that voltage changed from low to high.

sei(); //Enable the interrupt

cli(); //Disable the interrupt

Debug

Step 1: Copy the code to IDE and compile it.

Step 2: Set up circuit, as follows:

Microduino霍尔传感器测量电机RPM连接图.jpg

Note: Step 1: During setting up circuit, we will use Microduino-Cube-S1 board. This extension board was designed for OLED, only need plug in the Microduino-Core and Microduino-FT232R to slot and then connect the OLED to corresponding slot on Microduino-Cube-S1.

Step 2: As far as possible close hall sensor to DB motor, and easy to detect magnetic field changes.

Step 3: Run program.

Step 4: Rotate the potentiometer, observe the value on OLED.

Result

Rotate the potentiometer, motor will rotate. Hall sensor will induct motor's magnetic field changes regularly, to determine the frequency in one second and calculate the RPM, and then displayed on the OLED.

Video

http://v.youku.com/v_show/id_XNjkyNzk0MTQw.html