Wireless Communication
|
Microduino-nRF24
- Microduino 2.4G wireless module
- use SPI communication protocol
- Arduino library support
|
|
Microduino-smartRF
- 470/950 MHz ISM/SRD band ultra low power wireless communication module
- Use the SPI interface to communicate with Core/Core+ module
- Have corresponding networking library support, can carry on a simple network
- UPin-27 standard interface
|
|
Microduino-NFC
- Two-way connection and identification of near-field communication module
- Use IIC interface to communicate with Core/Core+ module
- UPin-27 standard interface
|
|
Microduino-BT
- Microduino Shield BT, two versions are provided: BT2.1 and BT4.0
- support BT 2.1/4.0 protocol
- use hardware serial or software serial ports (optional)
- UPin-27: Microduino standard interface
|
|
Microduino-Zigbee
- Microduino-Zigbee
- Adopt CC2530 chip
- Low-power, low-rate and low-cost two-way wireless communication
- UPin-27 standard interface
|
|
Microduino-WiFi
- Microduino WiFi Module
- Base on TI CC3000 IEEE 802.11b/g solution
- Use the SPI interface to communicate to Core module
- UPin-27: Microduino standard interface
|
|
Microduino-WIFI(ESP)
- WIFI communication module
- It can be connected to the Internet
- Communicate data with CoreUSB by serial port
|
|
Microduino-GPRS/GSM
- Microduino GPRS/GSM module
- Send, Receive short message
- Access the network using SIM card
|
|
Microduino-GPS
- Microduino GPS Module
- Core modules using UBLOX NEO-6M
- Use serial to communicate with Core module
- UPin-27: Microduino standard interface
|
|