Motion (use with mDesigner)
From Microduino Wiki
The motion sensor is a 3-axis gyroscope and 3-axis accelerometer. It is capable of detecting the angle and angular rate in the yaw, pitch, and roll axes (aircraft principal axes). Along with acceleration on the difference axes. Support for this module is found in mDesigner.
| Note: This module has a similar name to a Microduino / mCookie Motion module. They are NOT the same modules. mDesigner does not support the Microduino / mCookie Motion module. |
Compatible Pins
The following pins on the Hub or mCenter+'s Hub support this module:
| Pin Name | Compatibility | Notes |
|---|---|---|
| Pin 0 | No | |
| Pin 1 | No | |
| Pin 2 | No | |
| Pin 3 | No | |
| Pin 4 | No | |
| Pin 5 | No | |
| Pin 6 | No | |
| Pin 7 | No | |
| Pin 8 | No | |
| Pin 9 | No | |
| Pin 10 | No | |
| Pin 11 | No | |
| Pin 12 | No | |
| Pin 13 | No | |
| Pin A0 | No | |
| Pin A1 | No | |
| Pin A2 | No | |
| Pin A3 | No | |
| Pin A6 | No | |
| Pin A7 | No | |
| Pin I2C | Yes | Any I2C / IIC pin. |
