Sensor-LED

Language:	English  • 中文

mCookie-Hall The product number of mCookie Sensor—LED : MSDL11 mCookie Sensor-LED has red, yellow and green three colors. Introduction of the Sensor Pin Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx. Special to Sensor-LED sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Digital signal output PIN4(IO2): NC Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub. Features Low consumption Convenient interfaces Specification Sensor voltage 3.3V~5V working voltage Size of the sensor Size of the board: 23.5mm*13mm 1.27mm-spacing 4Pin interface connected with sensorhub CAD drawing of the sensor: File:Sensor CAD.zip Function description LED will twinkle with 1s as the interval. Connection This sensor can be connected with the following interfaces of the core: D2~D13 Document Schematic diagram: File:Microduino LED.Zip.pdf HAL49E datasheet: File:Microduino LED datasheet.pdf Development Program Download Download and unzip the program File:Microduino LED Test.zip Programming Follow the Software Getting Started Guide. Select the Board, Processor and Port. Click [File]->[Open], browse to the project program address, and click "Microduino_LED_Test.ino" to open the program. After confirming all these items are correct, click "→" to download the program to the development board. Hardware Setup Referring to the following picture, connect the Sensor-LED to the digital port D6 of Microduino-Sensorhub. Result LED will twinkle with 1s as the interval. Application Indicator lamp Projects Purchase History Gallery File:Microduino-LED-F.JPG mCookie-LED Front File:Microduino-LED-b.JPG mCookie-LED Back