Vibration Detection

Function of the Module Please refer to: Microduino-Shake As a digital input sensor, it can only detect "0" and "1", that is "Yes" and "No". Overview To use the Shake sensor to detect if there is vibration and print monitored data in the serial monitor. Bill of Material Module Module Number Function mCookie-CoreUSB 1 Core board mCookie-Hub 1 Sensor pin board Microduino-Shake 1 Vibration sensor Other Hardware Equipment One USB cable 600px Hardware Buildup Setup 1：Connect the interface of the Shake with the digital port (10) of the Hub. Accessible Hub pins: 0，2，4，6，8，10 and 12. 600px Setup 2：Connect the CoreUSB, Hub and Shake sensor to the computer with a USB cable. 600px Mixly Programming Step1：Since using serial monitor, we need to find "Serial Communication" from "Communication" item. Step2："Serial Communication" description. 600px Step3：The Shake sensor is an input device while the returned data is digital quantity, based on which we can find and drag out the digital input and output from "Input/Output". 600px "Digital Input" description. 600px Overall code description. 600px Debugging Step1：Select the right board card(Core USB 32U4) and COM port(Recognized automatically by default). Step2：Open the serial monitor. Step3：Check if the serial baud rate is the same with the pre-set one. Step4：Observe the data, which is "0" when no vibration happens and is "1" when there is a vibration. You can also see the indicator blink when there is a vibration. 400px