Sensor-Touch Button

Language:	English  • 中文

Microduino-TOUCH The product number of Microduino-TOUCH is: MSDS21 Microduino-TOUCH is capacitive touch detection sensor module. After the human body touch the two ends of the capacitance, the touch sensor can conduct electricity via the human body tissues and fluids, so the two ends of it change into low level. Breaking the touch, the capacitor starts charging in an instant, until the rated capacity of the capacitor, and at this time, the two ends of the capacitor is equivalent to open circuit, and the two ends of the touch sensor change into high level. Introduction of Sensor Pin Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx. Special to Sensor-Touch Button sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Digital signal input PIN4(IO2): NC Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub. Features With wide working voltage; With small size, which makes it easy to install; With capacitive sensing, and high sensitivity; With low power consumption, long service life, and good stability; With optional output locking and non-locking mode, which makes it convenient to use. Specification Voltage of the sensor 3.3V~5V working voltage Size of the sensor Size of the board: 23.5mm*13mm 1.27mm-spacing 4Pin interface connected with sensorhub CAD drawing of the sensor: File:Sensor CAD.zip Function description After touching the sensor, the digital output changes from 1 to 0. Connection This sensor can be connected to the following interfaces of the core: D2~D13 Document Schematic diagram: File:Microduino Touch Button.Zip' Touch Button datasheet：File:Microduino Sensor-Touch Button datasheet.pdf Development Program Download Download and unzip the program File:Microduino Sensor-Touch Button Test.zip Programming Follow the Software Getting Started Guide. Select the Board, Processor and Port. Click [File]->[Open], browse to the project program address, and click "Microduino_Sensor-Touch Button_Test.ino" to open the program. After confirming all these items are correct, click "→" to download the program to the development board. Hardware Setup Referring to the following picture, connect Sensor-Crash to the digital port D6 of Microduino-Sensorhub. Result After download, open the serial monitor. After the sensor is presses down, the digital output changes from 1 to 0. Application Touch button switch Projects Touching rainbow lamp Purchase History Gallery File:MicroduinoTouch Button-F.JPG mCookie-Touch Button-Front File:MicroduinoTouch Button-b.JPG mCookie-Touch Button-Back