Sensor-Servo Connector

Language:	English  • 中文

Sensor-Servo_Connector The product number of Sensor-Servo Connector is: MSDO41 Sensor-Servo Connector is used to link the servo with the interface of extension module. Introduction of Pins Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx. Special to Sensor-Servo Connector sensor pins PIN1: GND PIN2: VCC PIN3(IO1): IO1 PIN4(IO2): IO2 Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub. Servo Connector General Pin Out Sensor / Trinket's Pin Out PIN1 (GND) GND PIN2 (VCC) VCC PIN3 (SIGNAL-A) Digital Output (Servo Signal 1) PIN4 (SIGNAL-B) Digital Output (Servo Signal 2) General Pin Out is the standard pin out of a Sensor / Trinket connector. Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out. SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals. Not Connected refers to the Pin not being used for this particular Sensor / Trinket. Read more about the hub module. The servo can not link with the extension module (hub) directly, so a servo connector is needed. The servo connector have 3 above pins and 3 below pins, which can connect to two servos at the same time. When connecting the servo and the sevo connector, please pay attention to the "positive and negative" , and make sure that the GND, VCC, and 1/2 three wires are connected rightly. The above pins is corresponding to the odd pins of Hub, and the below pins is corresponding to the event pins of Hub. For example, when connecting the servo to the 6/7 pin of Hub, if the servo is connected to the below pins, the control pin is 6; to the above pins is 7. Application Used to connect up to 2 Servos to the 4 pin header on a Sensor Hub. Purchase Gallery File:Sensor-Servo Connector-F.JPG Sensor-Servo Connector Front File:Sensor-Servo Connector-b.JPG Sensor-Servo Connector Back