OLED (use with mDesigner)
From Microduino Wiki
The organic light-emitting diode (OLED) module is a display module capable of displaying information, shapes, images, etc on its 0.96-inch 128x64 (pixel) screen. Support for this trinket is found in mDesigner.
Connectivity
The OLED module can be connected to a project in two ways. Either stacking or connecting to a sensor hub using a wire.
Method 1: Stacking
Stack directly onto an mBattery or mCenter+.
Method 2: Connecting with Wire
Connecting the OLED screen to a sensor hub with a wire allows for the OLED to be positioned in different locations.
The following pins on the Hub or mCenter+'s Hub support this module:
| Pin Name | Compatibility | Notes |
|---|---|---|
| Pin 0 | No | |
| Pin 1 | No | |
| Pin 2 | No | |
| Pin 3 | No | |
| Pin 4 | No | |
| Pin 5 | No | |
| Pin 6 | No | |
| Pin 7 | No | |
| Pin 8 | No | |
| Pin 9 | No | |
| Pin 10 | No | |
| Pin 11 | No | |
| Pin 12 | No | |
| Pin 13 | No | |
| Pin A0 | No | |
| Pin A1 | No | |
| Pin A2 | No | |
| Pin A3 | No | |
| Pin A6 | No | |
| Pin A7 | No | |
| Pin I2C | Yes | Any I2C / IIC pin. |
Coordinates
The OLED screen has a screen resolution of 128 pixel wide by 64 high. The origin (0, 0) is on the top left of the screen (in reference to image below).
