Temperature & Humidity Sensor

Outline This mCookie sensor uses an AM2321 chip and the standard mCookie connector to give you the ability to quickly add high precision temperature measuring and humidity sensing to any Microduino project. The sensor has an on-board microprocessor delivering rapid response, high noise tolerance and excellent data quality. Specification Electrical Specifications Operation Voltage: 2.6~5V； Output: Data over I2C bus protocol Technical Specifications Resolution: 0.1 Degrees Celsius (°C) 0.1 percent (%) Relative Humidity Dimensions Dimensions of the Sensor: 8mm*11mm Dimensions of the Board: 20mm*10mm Connector Interface: 4 Pin, 1.27mm-pitch Communication Protocol Interface: I2C Pins: SDA (data), SCL (clock), VCC (power) and GND (ground) Development Equipment Module Number Function mCookie-CoreUSB 1 Core board mCookie-Hub 1 Sensor pin board Microduino-Temp&Hum 1 Sound detection sensor Other Hardware Equipment One USB cable Preparation Setup 1：Connect Microduino-Temp&Hum to the IIC port of the Hub. Setup 2：Stack the CoreUSB, Hub and Sound together and then connect them to the computer with a USB cable. Experiment: Detect Temp&Hum Values Open the Arduino IDE and copy the following code into IDE, or select from the examples built into the IDE: File->Examples->_07_Sensor_Temp_Hum_AM2321->'read_simple' #include <Wire.h> #include <AM2321.h> void setup() { Serial.begin(9600); } void loop() { readByAM2321(); delay(500); } void readByAM2321() { AM2321 am2321; am2321.read(); Serial.print("("); Serial.print(am2321.temperature/10.0); Serial.print(", "); Serial.print(am2321.humidity/10.0); Serial.println(')'); } Select the right board from Tools→Serial Port in Arduino IDE and download the program. Open the serial monitor after download; The value displayed reflects the current temperature and humidity. Program Debugging The program uses AM2321 temperature and humidity collection library and defines "#include <Wire.h>" and "#include <AM2321.h>" as driving files. The program uses two important libraries to communicate with the sensor. For any project/software that uses this sensor, the following libraries must be included: For the AM2321 sensor: "#include <AM2321.h>" For I2C Communication: "#include <Wire.h>" “am2321.temperature/10.0”represents the calculated temperature value and " am2321.humidity/10.0" represents the calculated humidity value. Application The Microduino Temperature and Humidity sensor can be used in a range of applications including HVAC systems, dehumidifiers, home automation, data recording or in a weather station. Video