Reclining Chair

From Microduino Wiki
(Redirected from Electric Chair)
Jump to: navigation, search


Overview

Anywhere Servo.jpg

Design a reclining chair of which the angle is adjustable.
Suitable kits: mCookie102, mCookie202, mCookie302, IBC


Module Bill

Module

Module Number Function
mCookie-Core 1 Core board
Battery box 1 Program download and power supply
mCookie-Hub 1 Sensor adapter plate
Servo 1 Servo
Servo Connector 1 Servo Connector

Other Equipment

  • USB cable*1
  • Sensor cable*1
  • Sensor shell*1
  • Lego or other fixation structures
Anywhere Servo-module.jpg

Servo
Servo is a complicated electric mechanical structure and its main axis can rotate to any specified angle between 0-180 degrees according to electricity signal. It is usually used as a rudder to control the direction for airplane, vehicle and ship models, that is why it is called servo.

Anywhere Servo-lego.jpg

Install the rocker
No matter what the installation angle of the rocker us, the angle which the rocker can rotate to clockwise is 0°controlled by the program, and similarly, the anticlockwise angle is 180°. In this course, we need to make the rocker rotate between the angles on the above diagram, turn the rocker slowly and observe the rotation range, no brute force please.

Anywhere Servo-legobi.jpg

If you find that the rotation range of the rocker doesn’t meet the requirement, as shown on the left diagram, you need to dismount the fixation screws of the rocker with a screwdriver, unplug the rocker, turn it to a certain angle and then install it back to the main axis and rotate it again and observe the rotation range.

Anywhere Servo-legobi1.jpg

Servo Connector
Servo can't be connected to extension module (Hub) directly, it needs the help of servo connector. There are six pins, 3 up, 3 down, of the servo connector, which can be connected to two servos at the same time.

Anywhere Servo-Servo Connector.jpg

Pay attention to the positive and negative when connecting the servo to the servo connector, and make sure that the GND, VCC, and 1/2 three wires are in right position. The above pins correspond to the odd pins of Hub, and the below correspond to the even pins of Hub. For example, if you want to connect the connector to pin 6/7 of Hub, if you connect the servo to the below pins, the control pin is 6, if connect to the up pins, the control pin is 7.

Anywhere Servo-Servo Connector1.jpg


Module Setup

Anywhere Servo-module—step.jpg
  • Assemble all modules and sensors together:
    • Stick the red core module, USB upload module and green extension module together;
    • Connect the servo connector pin pin 6/7 of Hub;
    • Connect the servo to pin 1 (the below three pins) of servo connector;
    • Plug one end of USB cable into USB upload module, and connect the other end to the computer.

Programming

Required Program Block

"Servo" program block

Programming Thought

We can control the servo rocker to rotate to any single between 0~180°, just need to make the rocker rotate to an specified angle, and fix the back of the chair on the rocker.

Start to Program


Connect the servo to pin 6 of Hub with the connector, and then make it rotate to 10°with the speed of 100 degrees/s.

Mixly-ctrl-Servo-code.jpg
  • Test the result
    • After uploading the program, make the servo rotate to the position of 10 degrees. Fix the back of the chair on the servo rocker with a wire or other things.
Anywhere Servo.jpg

Technical Specification

  • For details about servo, please refer to Servo.

Related Cases

Q&A