Difference between revisions of "Sensor-Dust"

• General Pin Out is the standard pin out of a Sensor / Trinket connector.
• Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
• SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
• Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
• Read more about the hub module.

Features

• Adopt SHARP GP2Y1010AUOF air quality sensor;
• Serial port communication.

Specification

• Sensor voltage
  • 3.3V~5V working voltage

• Sensor size
  • Board size: 23.5mm*13mm
  • 1.27mm-spacing 4Pin connected with sensorhub
  • The CAD drawing of the sensor: File:Sensor CAD.zip

• Connection
  • This sensor can be connected to the following interfaces: D4/D5

Document

• Schematic diagram: File:Sensor-Dust.Zip
• Main sensor: File:Sensor-Dust datasheet.pdf

Development

Program Download

• Download and unzip the program File:Sensor-Dust Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Sensor-Dust Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following diagram, connect the Sensor-Dust to digital interface D4/D5 of Microduino-Sensorhub.

Result

• After download, open the serial monitor.
• The detected PM2.5 intensity will be printed out in cycle in the serial monitor.

Application

It can be used to detect the air quality and indoor dust and so on.

Purchase