Difference between revisions of "Sensor-Temperature-D1"

• General Pin Out is the standard pin out of a Sensor / Trinket connector.
• Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
• SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
• Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
• Read more about the hub module.

Features

• Adopts LM75 temperature whose address is optional.
• With high accuracy and sensitivity.
• With low power consumption, long service life and good stability.
• With wide working voltage.
• With small size which is easy to install.

Specification

• Sensor voltage
  • 3.3V~5V working voltage

• Size of the sensor
  • Size of the board: 23.5mm*13mm
  • 1.27mm-spacing 4Pin interface connected with sensorhub
  • CAD drawing of the sensor: File:Sensor CAD.zip

• Technical parameters
  • Accuracy: temperature 0.125℃;
  • Measuring range: 55℃～+125℃;

• Connection
  • This sensor can e connected to the I2C interface of the core.

Document

• Schematic diagram: File:Sensor-Temperature-D1.Zip
• Main chip: File:LM75 datasheet.pdf

Development

Program Download

• Download and unzip the program File:Sensor-Temperature-D1 Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Sensor_Temperature_D1_Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following diagram, connect the Sensor-Temperature-D1 to the I2C interface of Microduino-Sensorhub.

Result

• After download, open the serial monitor.
• The serial monitor will print out the configuration information of the sensor, and then display the current temperature in cycle.

Application

It can be used to detect the humidity of the environment, and be sued as temperature switch to control the air conditioner, fan and other devices.

Purchase

History

Gallery

• Front

• Back