Difference between revisions of "Sensor-LED"

• General Pin Out is the standard pin out of a Sensor / Trinket connector.
• Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
• SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
• Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
• Read more about the hub module.

Features

• With small size which is easy to install.
• Three different color variants: red, green, yellow.

Specification

• Sensor voltage
  • 3.3V~5V working voltage

• Size of the sensor
  • Size of the board: 23.5mm*13mm
  • 1.27mm-spacing 4Pin interface connected with sensorhub
  • CAD drawing of the sensor: File:Sensor CAD.zip

• Function description
  • GPIO controls the high and low electricity of LED to emit light.

• Connection
  • This sensor can be connected with the following interfaces of the core: D2~D13, D2~D13

Document

• Schematic diagram: File:Sensor- LED.Zip.pdf

Usage

Basic Functionality

The LED Trinket is a simple trinket which emits light when passed with a sufficient voltage. A Core module can supply voltage to the LED Trinket.

Programming

//Define the pin the sensor is connected to
const int LED_PIN = 6;

void setup() {
  // put your setup code here, to run once:

  //Initial serial communication port at 9600 baud
  Serial.begin(9600);

  //Configure the pin into output mode
  pinMode(LED_PIN, OUTPUT);
}

void loop() {
  // put your main code here, to run repeatedly:

  //Perform a digitalWrite with HIGH to turn on the LED
  digitalWrite(LED_PIN, HIGH);

  //Delay 1 second
  delay(1000);

  //Perform a digitalWrite with LOW to turn off the LED
  digitalWrite(LED_PIN, LOW);

  //Delay 1 second
  delay(1000);
}

Program Download

• Download and unzip the program File:Sensor-LED.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Microduino_LED_Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following picture, connect the Sensor-LED to the digital port D6 of Microduino-Sensorhub.

Result

• LED will twinkle with 1s as the interval.

Application

• Indicator lamp

Projects

Purchase

History

Gallery