Difference between revisions of "Sensor-IO Split"

• General Pin Out is the standard pin out of a Sensor / Trinket connector.
• Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
• SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
• Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
• Read more about the hub module.

• All interfaces of Sensor-IO Split are 1.27mm-spacing 4Pin.

After connect the IN interface to one interface of SensorHub, the extended “A port” is corresponding to the “even pins” of SensorHub, and the “B interface” is corresponding to the “odd pins” of SensorHub.

For example, connecting to the 6/7 pin of Hub, the corresponding pin of A is 6/7, and the corresponding pin of B is 7.

Document

• Schematic diagram: File:Sensor IO-split.Zip

Application

It can be used to divide the two IO signals of one 4PIN port in Sensorhub into two 4PIN ports.

Purchase

Gallery