Bluetooth Night Light

Language:	English  • 中文

Objective When it gets dark, the night light starts to work. You can control the color and brightness of the light through Bluetooth. Principle With the Light sensor to detect light intensity, so system can tell the light status. If the surrounding light is too strong, the Color LED light will turn off. You can use phone Bluetooth to control the color of the light. Equipment Module Number Function Microduino-CoreUSB 1 Core board Microduino-Sensorhub 1 Sensor pinboard Microduino-BT 1 Bluetooth module Microduino-Light 1 Light-sensitive sensor Microduino-Color LED 1 Colored LED light Microduino-BM 1 Battery management 600px Preparation Setup 1: Use a USB cable to connect the CoreUSB and PC/Mac, then open Arduino IDE. Setup 2: Click file >examples > mCookie > _201_CowardlyNightLight_BLE, and download the program. Setup 3: Load the code, choose the right board and COM port for program download after compiling. Program Description "ble()" function is for Bluetooth data receiving and light control. Define Bluetooth Communication serial port. #define my_Serial Serial1 Define the pin of sensors as well as the number of lights connected. #define PIXEL_PIN 6 // Digital IO pin connected to the NeoPixels. #define PIXEL_COUNT 2 #define lightSensorPin A0 Surrounding light pre-set value: Change the value and you can change the brightness. #define lightSwitch 700 Read brightness function sensorValue = analogRead(lightSensorPin); Judge whether the surround light parameter is lower than the pre-set value or not. If yes, the light will be turned on and can be controlled through Bluetooth. Otherwise, the light will be turned off. if(sensorValue>lightSwitch) { Serial.println(sensorValue); strip.setPixelColor(0, strip.Color(0, 0, 0)); strip.setPixelColor(1, strip.Color(0, 0, 0)); strip.show(); } else { ble(); if (!color_en) { for (int i = 0; i < 1; i++) rainbow(10); } } Code Debugging Connect the CoreUSB with a computer, download the program and open the serial monitor. Inside the monitor, you can see light value change received by the Light sensor. The current setting value is 700. You can try to change the value in the program according to the previously detected data and download the program to see what happens. Hardware Buildup Setup 1: Connect the Color LED to the Sensorhub D6 and the Light sensor to A0. For the connection of LED, please refer to the picture below. Please be noted of the connection order, which is from LED's IN interface e to OUT. Here you can control two LED lights at most. Setup 2: Connect the activated battery box with the BM module. Setup 3: Stack all modules together without a fixed order. Congratulations! You've finished the circuit buildup. APP Debugging Setup 1: Scan the two-dimensional code on the left, download Bluetooth Light APP. Setup 2: Open the APP after the download and installation. The system will remind you to choose to open Bluetooth if it is disconnected. Setup 3: Click Scan and the phone will start searching Bluetooth devices, which are displayed below. Here you can select Microduino device. Setup 4: After the connection, you can use your phone to control the light. Result Cover the light sensor, or go into the dark environment, the LED light will shine. Then you can use the Bluetooth to control the color of the light. You can also build a beautiful look through Lego since mCookie can be freely stacked LEGO boards. Video