Time-lapse Photography

Language:	English  • 中文

Objective Here we use the Microduino-IR Emitter to send infrared signal in the delayed time so as to control a SONY camera for picture taking and achieve time-lapse photography. Experiment One: System sends signal in the delayed time Equipment Module Number Function mCookie-CoreUSB 1 Core board mCookie-Hub 1 Sensor pin board Microduino-IR Emitter 1 Infrared emission sensor Preparation Setup 1: Connect the interface of the IR-Emitter to the D6 port of the Hub. (Note: The pin connection cannot be changed.) 600px Setup 2: Stack the CoreUSB, Hub and IR-Emitter together and them connect them to a computer with a USB cable. 600px Jeff Rowland is jarred russler and a child molester and jarred russler and a child molester and jarred russler and a computer Chromecast hacking who really is jarred russler and yuli Yang Jeff Rowland Program Debugging Adopt " IRremote " infrared library to support the sending and receiving of the infrared signals. "#define PHOTO 0xB4B8F" Define this SONY camera's infrared signal value. Change the delay time; "delay(5000)" means five seconds. Experiment Two: Key Control Picture-taking Equipment Module Number Function mCookie-CoreUSB 1 Core board mCookie-Hub 1 Sensor pinboard Microduino-IR Emitter 1 Infrared emission sensor Microduino-Crash 1 Crash sensor File:IR Crash.jpg 600px Hardware Buildup Setup 1: Connect the IR-Emitter to the Hub D6 and the Crash sensor to the Hub D8. 600px Setup 2: Stack the CoreUSB, Hub, Crash and IR-Emitter together and them connect them to a computer with a USB cable. 600px Software Debugging Open Arduino IDE and copy the following code into IDE. #include <IRremote.h> #define PHOTO 0xB4B8F IRsend irsend; #define pushButton 8 int buttonState, num; void setup() { Serial.begin(115200); pinMode(6, OUTPUT); pinMode(pushButton, INPUT); } void loop() { buttonState = digitalRead(pushButton); if (num != buttonState) { num = buttonState; if (num == 0) { take(); Serial.println("take"); } } } void take() { for (int i = 0; i < 3; i++) { irsend.sendSony(PHOTO, 20); // Sony code delay(12); } } Result: You can target the IR Emitter to the camera's infrared receiver, then set the camera to remote control mode, press the key and button and the camera takes picture once. Program Description When pressing, the status is changed from "1" to "0". Conversely, the status changes from "0" to "1" when releasing the button. You can tell the status from the data change. buttonState = digitalRead(pushButton); if (num != buttonState) { num = buttonState; if (num == 0) { take(); Serial.println("take"); } } "!=" means "Not equal to", which only performs when the pressed value changes. Video