|
|
The product number of mCookie Sensor—LED: MSDL11
The LED controlled by GPIO directly has three color types: red, green, and yellow.
Introduction of the Sensor Pin
Single Color LED
| General Pin Out
|
Sensor / Trinket's Pin Out
|
| PIN1 (GND)
|
GND
|
| PIN2 (VCC)
|
VCC
|
| PIN3 (SIGNAL-A)
|
Digital Output
|
| PIN4 (SIGNAL-B)
|
Not Connected
|
- General Pin Out is the standard pin out of a Sensor / Trinket connector.
- Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
- SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
- Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
- Read more about the hub module.
Features
- With small size which is easy to install.
- Three different color variants: red, green, yellow.
Specification
- Size of the sensor
- Size of the board: 23.5mm*13mm
- 1.27mm-spacing 4Pin interface connected with sensorhub
- CAD drawing of the sensor: File:Sensor CAD.zip
- Function description
- GPIO controls the high and low electricity of LED to emit light.
- Connection
- This sensor can be connected with the following interfaces of the core: D2~D13, D2~D13
Document
Development
Program Download
Programming
Hardware Setup
- Referring to the following picture, connect the Sensor-LED to the digital port D6 of Microduino-Sensorhub.
Result
- LED will twinkle with 1s as the interval.
Application
Projects
Purchase
History
Gallery
|
