LM75 Temperature Detection

Function of the Module Please refer to: Temperature & Humidity Sensor Temperature range: -40-80℃. This sensor is not water-proof so you can't put it into the water and measure temperature and humidity. Overview To use the Temp& Hum sensor to detect surround temperature and humidity and check data in the serial monitor. Bill of Material Module Module Number Function mCookie-CoreUSB 1 Core board mCookie-Hub 1 Sensor pin board Microduino-Temp&Hum 1 Temperature and humidity sensor Other Hardware Equipment One USB cable Hardware Buildup Setup 1：Connect the Temp&Hum sensor to the IIC port of the Hub. (Only connected to IIC) Setup 2：Connect the CoreUSB, Hub and Temp&Hum sensor to the computer with a USB cable. 600px Mixly Step1：Since we use the serial monitor, we need to find "Serial communication" from "Communication" item. Step2：Serial communication description. 600px Step3：Find "Temp&Hum module " from "Sensor" under the item of "Microduino". 600px "Temp&Hum module " description 600px You can find "Print" in "Text" if you need to print self-defined content. Overall code description. 800px Debugging Step1：Select the right board card(Core USB 32U4) and COM port(Recognized automatically by default). Step2：Open the serial monitor. Step3：Make sure the serial baud rate is the same with the pre-set one. Step4：Check the data: When hold the sensor with your hand, the temperature and humidity will increase but the humidity is climbing faster that temperature. 400px