Case 1:Stars Lamps
Outline
Lit a lamp through the graphical.
Bill of Materials
- Other equipment
- USB cable*1
- Sensor cable*1
Building hardware
- Setup 1: Connect the interface on the back of the ColorLED with the digital interface (4) of Hub to be the pin that control the LED, and users can change it freely.
- Setup 2: Connect CoreUSB, Hub, and the single-color LED together, and connect them to the computer with USB cable.
Mixly Programming
- Step 1: Open the Mixly software, and drag the at the "number output" module in "input/output" tab control to theediting area.
- Step 2: The introduction of the “number output” module.
Debugging
- Step1: Choose the board card(CoreUSB(32u4)[usb32u416m])
- Step2: Choose the COM port.
- Step3: Upload the program.
- After succeeding, the single-color LED lights with red color.
- The above is based on being debugged on the computer. After uploading successfully, the code is in the core, and can also use battery box to supply power.
- Connect the active battery box with the BM module.
|