Difference between revisions of "Sensor-Color Detector"

From Microduino Wiki
Jump to: navigation, search
(Development)
(Application)
Line 69: Line 69:
  
 
==Application==
 
==Application==
Microduino-Color detector is suitable for environment color detection.  
+
Suitable for environment color detection and so on.  
  
  
 
===Project===
 
===Project===
 
* '''[[Chameleon]]'''
 
* '''[[Chameleon]]'''
 
  
 
==Purchase==
 
==Purchase==

Revision as of 02:29, 9 November 2016

Language: English  • 中文
Microduino-ColorDetector

The product number of Sensor-Color Detector is: MSDT51

Microduino-Color detector is a color detection sensor.

This module adopts TCS3414CS color chip. Based on 8×2 filtered photodiode and 16-bit analog-digital converter, you can measure light or light reflection on the surface of an object to acquire color value.



Introduction of Sensor Pins

Sensor backpin.png
  • Pins of the sensor:
    • PIN1: GND
    • PIN2: VCC
    • General signal pins:
      • PIN3(IO1): digital/analog signal
      • PIN4(IO2): NC(null)
    • Special signal pins:
      • If it is IIC: IO1/IO2 are respectively SDA/SCL.
      • If it is soft serial port: IO1/IO2 are respectively tx/rx.
  • Special to Sensor-Color Detector sensor pins
    • PIN1: GND
    • PIN2: VCC
    • PIN3(IO1): SDA(IIC communication)
    • PIN4(IO2): SCL(IIC communication)


Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

Features

  • With high accuracy and sensitivity;
  • With low consumption, long service life and high stability;
  • Small and easy to install.

Specification

  • Sensor voltage
    • 3.3V~5V working voltage
  • Size of the sensor
    • Sensor of the board: 23.5mm*13mm
    • 1.27mm-spacing 4Pin interface connected to sensorhub
    • The CAD drawing of the sensor: File:Sensor CAD.zip
  • Technical parameter
    • Working temperature: -40 ~ 85 °C
  • Connection
  • This sensor can be connected to pin I2C of core.

Document

Development

Program Download

Programming

  • Follow the Software Getting Started Guide.
  • Select the Board, Processor and Port.
  • Click [File]->[Open], browse to the project program address, and click "Sensor-Color Detector Test.ino" to open the program.
  • After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

  • Referring to the following diagram, connect the Sensor_Color_detector to IIC interface of Microduino-Sensorhub.


Microduino-sensorhub I2C.JPG


Result

  • After download, open the serial monitor.
  • Putting the sensor toward different colors, the serial monitor will print out the current RGB value in cycle.

Application

Suitable for environment color detection and so on.


Project

Purchase

History

Pictures

  • Front
Microduino-Temp&Hum Front
  • Back
Microduino-Temp&Hum Back