|
The product number of Sensor-Color Detector is: MSDT51
Microduino-Color detector is a color detection sensor.
This module adopts TCS3414CS color chip. Based on 8×2 filtered photodiode and 16-bit analog-digital converter, you can measure light or light reflection on the surface of an object to acquire color value.
Introduction of Sensor Pins
Color Detector Sensor
| General Pin Out
|
Sensor / Trinket's Pin Out
|
| PIN1 (GND)
|
GND
|
| PIN2 (VCC)
|
VCC
|
| PIN3 (SIGNAL-A)
|
IIC SDA
|
| PIN4 (SIGNAL-B)
|
IIC SCL
|
- General Pin Out is the standard pin out of a Sensor / Trinket connector.
- Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
- SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
- Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
- Read more about the hub module.
Features
- With high accuracy and sensitivity;
- With low consumption, long service life and high stability;
- Small and easy to install.
Specification
- Size of the sensor
- Sensor of the board: 23.5mm*13mm
- 1.27mm-spacing 4Pin interface connected to sensorhub
- The CAD drawing of the sensor: File:Sensor CAD.zip
- Technical parameter
- Working temperature: -40 ~ 85 °C
- Connection
- This sensor can be connected to pin I2C of core.
Document
Development
Program Download
Programming
Hardware Setup
- Referring to the following diagram, connect the Sensor_Color_detector to IIC interface of Microduino-Sensorhub.
Result
- After download, open the serial monitor.
- Putting the sensor toward different colors, the serial monitor will print out the current RGB value in cycle.
Application
Suitable for environment color detection and so on.
Project
Purchase
History
Gallery
|
