Difference between revisions of "Sensor-Moisture"

Sensor-Moisture

The product number of Sensor-Moisture is: MSDT23 Sensor-Moisture is a soil humidity detection sensor.

Introduction of Sensor Pins

Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx.

Special to Sensor-Moisture sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Analog read PIN4(IO2): NC Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub.

Features

• Resistance-type humidity sensitive component with high sensitivity;
• Low consumption and high stability;

Specification

• Sensor voltage
  • 3.0V~5.5V working voltage
• Size of the sensor
  • Size of the board: 23.5mm*13mm
  • 1.27mm-pitch 4PIN interface connected to sensorhub;
  • CAD drawing of sensor: File:Sensor CAD.zip
• Technical parameter
  • Output: 0~5V analog signal
• Connection
  • This sensor can be connected to the following pins of core: A0~A7

Document

• Schematic diagram: File:Microduino Moisture.Zip
• Main sensor: File:Sensor-Moisture datasheet.pdf

Development

Program Download

• Download and unzip the programFile:Sensor-Moisture Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Sensor-Moisture Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following diagram, connect the 将Sensor-Moisture to analog pin A0/A1 of Microduino-Sensorhub/zh.

Result

• After download, open the serial monitor
• The return value of the sensor is "0.00" when it doesn't touch anything, and the value will be larger than 0 when it touches the soil. The displayed value respresents the moisture of the soil.

Application

• All hardware needed: Microduino-Core, Microduino-USBTTL, Microduino-Sensorhub, a USB cable and wires;
• Software:　　
  • Make sure you build Microduino IDE. If not, please refer to: Microduino Getting start
• Stack all modules and connect the Moisture module to A0 port of Sensorhub with a wire.
• Open Arduino IDE, select File→Examples→Basics→ReadAnalogVoltage program examples, choose the right board from Tools→Board and then compile.
• Select the right port from Tools→Serial Port in Arduino IDE after compiling, then download program.
• After download, you can open the serial monitor and tell soil humidity from the displayed value, which is "0.00" when the Moisture sensor doesn't touch any object and will become bigger than 0" when touching the soil.

Purchase

History

Pictures

• Front

• Back