Difference between revisions of "Sensor-Color Detector"

• General Pin Out is the standard pin out of a Sensor / Trinket connector.
• Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
• SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
• Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
• Read more about the hub module.

Features

• With high accuracy and sensitivity;
• With low consumption, long service life and high stability;
• Small and easy to install.

Specification

• Sensor voltage
  • 3.3V~5V working voltage

• Size of the sensor
  • Sensor of the board: 23.5mm*13mm
  • 1.27mm-spacing 4Pin interface connected to sensorhub
  • The CAD drawing of the sensor: File:Sensor CAD.zip

• Technical parameter
  • Working temperature: -40 ~ 85 °C

• Connection
• This sensor can be connected to pin I2C of core.

Document

• Schematic diagram: File:Sensor-Color detector.Zip
• Main chip: File:TCS3414FN datasheet.pdf

Development

Program Download

• Download and unzip the program File:Sensor-Color Detector Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Sensor-Color Detector Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following diagram, connect the Sensor_Color_detector to IIC interface of Microduino-Sensorhub.

Result

• After download, open the serial monitor.
• Putting the sensor toward different colors, the serial monitor will print out the current RGB value in cycle.

Application

Suitable for environment color detection and so on.

Project

• Chameleon

Purchase

History

Gallery

• Front

• Back