Sensor-IR Sensor

Language:	English  • 中文

Sensor-IR-Sensor The product number of Sensor-IR Sensor is: MSDI21 Sensor-IR Sensor is infrared emission sensor module. Instruction of Sensor Pin Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx. Special to Sensor-IR Sensor sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Digital signal input（pwm） PIN4(IO2): NC Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub. Features With small power and high sensitivity. With small size which is easy to install. Specification Electric specification 3.3V~5V working voltage Output device Technical parameters Ir: 1~3 µm Size Size of LED: 5mm*5mm Size of board: 20mm*20mm 1.27mm-spacing 4Pin interface Connection Instruction of pins: GND, VCC, signal output, NC(null), and the input signal is digital signal, so you need to use the digital interface with PWM function to drive it. And you can connect it to the pin 6 of Sensor-hub, and the corresponding pin is D6. File:Microduino-IR-transmitter rule1.jpg 600px Document Schematic diagram: File:Microduino IR-transmitter.Zip Development Preparation Confirm that you has set up the development environment of Microduino, otherwise please refer to : Microduino Getting started Core choose 1.Adopt Microduino-CoreUSB or mCookie-CoreUSB as the core directly. 2.Adopt Microduino-Core or Microduino-Core+, and you also need Microduino-USBTTL to download program. Program Open the program "IRsendDemo" in the library. include <IRremote.h> Call the infrared library function. IRsend irsend; Define the infrared sending object. irsend.sendSony(0xa90, 12); Send the infrared coding. Hardware Setup Stack all modules together, and connect the interface on the back of IR-transmitter and the digital port (D3) of Sensorhub with dupont line. Microduino-Sensorhub mCookie-Hub Connect Sensorhub with LED, and connect them to the computer with USB cable. Select the right board card and COM port, and download directly after compiling. You can refer toAVR Core: Getting Started Open Arduino IDE, choose File→Examples→Microcuino→Sensor_IRremote→IRsendDemo the sample program, select the right board card in Tools→Board, and then compile. After compiling, choose the right port in Tools→Serial Port of Arduino IDE, adn then download the program directly. After downloading, you can open the serial monitor, and you can see the LED on IR emitter module twinkles once after input any value to the control panel, saying the infrared signal has been sent. Application It can be used in infrared remote controller to control various household appliances. At first, you need to confirm the infrared signal type and the protocol format. Projects Purchase History Gallery Front Microduino-IR-transmitter Front Back Microduino-IR-transmitter Back