Difference between revisions of "Sensor-IR Sensor"

• General Pin Out is the standard pin out of a Sensor / Trinket connector.
• Sensor / Trinket's Pin Out is this specific Sensor / Trinket's wiring in relation to the General Pin Out.
• SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
• Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
• Read more about the hub module.

Features

• With small power and high sensitivity.
• With small size which is easy to install.

Specification

• Voltage
  • 3.3V~5V working voltage

• Size
  • Size of the board: 23.5mm*13mm
  • 1.27mm-spacing 4Pin interface connected with sensorhub
  • The CAD drawing of the sensor: File:Sensor CAD.zip

• Technical parameter:
  • Infrared spectrum: 1~3 µm

• Connection
  • This sensor can be connected to the following interfaces of core:
    • For Microduino-Core: D3（swap the positions of the I01/IO2 signal wires on one end of the sensor cable）
    • For Microduino-Core+: D8
    • For Microduino-CoreUSB: D6
    • For Microduino-CoreRF: D5

Document

• Schematic diagram: File:Sensor-IR Sensor.Zip
• Main chip: File:TSAL6200 datasheet.pdf

Development

Program Download

• Download and unzip the program File:Sensor-IR Sensor Test.zip

Programming

• Follow the Software Getting Started Guide.
• Select the Board, Processor and Port.
• Click [File]->[Open], browse to the project program address, and click "Sensor-IR-Sensor Test.ino" to open the program.
• After confirming all these items are correct, click "→" to download the program to the development board.

Hardware Setup

• Referring to the following diagram, connect the Sensor-IR Sensor to digital pin D3 of Microduino-Sensorhub.

Result

• After download, you can open the serial monitor.
• Input a random value on the serial monitor, and you will see the LED on IR Sensor flash once, representing the IR signal has been sent.

Application

It can be used in infrared remote controller to control various household appliances. At first, you need to confirm the infrared signal type and the protocol format.

Projects

Purchase

History

Gallery

• Front

• Back