Sensor-Air Quality

Language:	English  • 中文

Microduino-Air-quality The product number of Sensor-Air is: MSDT61 Sensor-Air is an air quality sensor module. TP401T air quality sensor shows great sensitivity towards alcohol, cigarettes, ammonia, sulfide and other pollution sources. Introduction of Sensor Pins Pins of the sensor: PIN1: GND PIN2: VCC General signal pins: PIN3(IO1): digital/analog signal PIN4(IO2): NC(null) Special signal pins: If it is IIC: IO1/IO2 are respectively SDA/SCL. If it is soft serial port: IO1/IO2 are respectively tx/rx. Special to Sensor-Air Quality sensor pins PIN1: GND PIN2: VCC PIN3(IO1): Analog signal read PIN4(IO2): NC Microduino sensor can communicate with core module through the connection with Microduino-Module Sensor Hub. Features Show great sensitivity towards VOCS and odorous gas such as ammonia, alcohol, hydrogen sulfide, toluene and hydrogen. Low consumption Sensitive for air pollution. long product life and low price Easy to use Specification Electrical specification Output: 0~5V analog signal Operation voltage: 3.0V~5.5V Tech parameters Measurement range: 1-100ppm Sensitivity: 0.15-0.45ppm Size Size of the sensor: 5mm*5mm Size of the board: 20mm*10mm 1.27mm-pitch 4Pin interface; Connection method Pin description: GND, VCC, signal output and NC(empty). Note: Since the input signal is simulated, it needs analog interface to detect (A0-A7), which can be connected to the pins(A6/A7,A2/A3 and A0/A1) of the Sensorhub. File:Microduino-Light rule1.jpg 600px Document Schematic diagram: File:Microduino AirQuanlity.Zip Development Preparation Make sure you build Microduino IDE or refer to: Microduino Getting started Core selection 1. Adopt Microduino-CoreUSB or mCookie-CoreUSB as the core. 2. Adopt Microduino-Core or Microduino-Core+ as the core plus Microduino-USBTTL as the program download module. Program Open " AnalogInput " in the libraries. int sensorPin = A0; Define the analog A0 as the input pin. sensorValue = analogRead(sensorPin); Read values of the pin. Hardware Buildup Stack all modules together and then connect the air quality sensor to the A0 slot of Microduino-Sensorhub with the wire. For reference: Microduino-Sensorhub For reference: mCookie-Hub Connect the core, Sensorhub and the Microduino-Air to a computer with a USB cable. Select the right board and COM port, compile and download. You can refer to AVR Core：Getting started Select the right port number from Tools→Serial Port in Arduino IDE after compiling, then download the program. Open the serial monitor after download. The values displayed on the serial monitor reflect the current air quality. Application Air cleaner, air conditioner and fresh air detector. Project Weather Station Purchase History Pictures Front File:Microduino-AirQuality-F.JPG Microduino-Light Front Back File:Microduino-AirQuality-b.JPG Microduino-Light Back